Guangzhou Matec Electronics Co.,Ltd
xenon-hidlamps.com
Add to Cart
7cm*5cm*2cm Aluminum Shell DC9V 30W Mini G6 Motorcycle HID Light Kits Ballast
G6 is a hi/lo beam controller build-in ballast with very good quality in less than 1% defective which used in motor cycle HID conversion system.
Input Voltage: DC7.5V-DC16V
Almost all of the motorcycle HID ballasts are DC9V input, but most of motorcycles battery are in lower than 9V voltage which may makes HID disabled in starting, we solved this problem.
Output Power:30W
In the market there are two types of ballast for motorcycle----25W or 35W. But when we install HID into motorcycle, 25W will be lack of brightness, and 35W used too much electricity, one of the bad results is: motorcycle can not been started because the electronic starter can not get enough electricity from battery.
Compacted size: 7cm*5cm*2cm
The size of this ballast is7cm*5cm*2cm, this makes it can be installed into >95% motorcycle headlight (between reflector and back shell).So it’s easy for installation.
High Quality:
Less than 1% defective rate. This rate is just 1/10 of competitors.
Good in heat release:
Aluminum shell makes it is of good performance on heat-release, this will make the ballast works for longer time than those competitors’ ballast with plastic shell